With the same dimensions it should work fine but keep in mind that the point should be hard enough to actually be able to scribe in the metal. Perhaps one could use a metal rod in stead of a precision screwdriver. I did try out another generic brand which had the same kind of filling but the scriber didn't retract because the pen already had a faulty mechanism to begin with (testing before is handy sometimes). I used a pen of the Parker brand, simply because that was at hand and both the filling and the screwdriver had more or less the same dimensions. I can carry it with me without worrying of loosing it or more importantly: injuring myself or damaging my clothes. I therefore call it my "Portable Scriber" -) You could also use a file to get the same result, it only takes longer and requires more "elbow grease".Īfter testing, the scriber works just like a "normal" scriber but this one can also be handled as an everyday ballpoint pen. I found both steps easy to do since I put the screwdriver in a cordless drill and sanded it with a bench grinder. Because it was a screwdriver to begin with, the metal should be hard enough that no extra hardening is required. Since scribers work best with pointy edges, you also need to sharpen it. Use the hacksaw to remove the top and sand it so that it fits the plastic. Mark it with a sharpy or use some tape in order not to grind off too much material. Lay both the screwdriver and the filling besides each other and mark where you need to cut the screwdriver's head off, keeping in mind it needs to fit in the hole of the plastic and at the same time needs to have the same dimensions as the original filling. Clean the screwdriver in order to be able to freely move up and down the pen (in my case I had to remove the rust with sandpaper).Įxamine the hole in the plastic and notice the dept and width of it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |